Three 80 MHz video ports with capture / display buffers, also excellent to interface high-speed A/D- and D/A converters
High bandwidth interfaces to data acquisition peripherals and FPGAs: 533M-Bytes/s parallel bus
High-speed USB2.0 peripheral controller
Dual UART with auto-flow control, receive and transmit FIFOs, RS232 and RS422/485 interface
10Base-T / 100Base-TX Ethernet controller
Large on-board memories: 64M-Byte SDRAM, 8M-Byte Flash
3.3V single-supply, Supervisor and Watchdog
D.Module.BIOS programming support for all on-board resources, USB / RS232-based Setup Utility for convenient field-maintenance
Ordering Info: Part No. See below
Description
The D.Module2 series represents the next generation of high-performance,stand-alone DSP boards. These boards are optimized for highest I/O bandwidth to satisfy
demanding applications. The 32-bit wide external bus, configured in synchronous mode, can transfer
up to 533 Mbytes/s of data between DSP and peripherals.
The self-stacking design allows users to build complete signal
processing systems by stacking the required DSP, I/O, data acquisition,and networking modules. If data preprocessing is needed an FPGA module can be inserted
between data acquisition and DSP.
Besides the high-speed peripheral bus all D.Module2 DSP boards provide a variety of interfaces: two UARTs, an USB2.0 peripheral controller, user-programmable I/O ports, and synchronous serial interfaces. An extra connector
is reserved for DSP-specific extensions like the video ports available on the DM642 module.
Ordering Information
D.Module2.DM642: Standard module
Option: -I Industrial temperature grade
DS.DM642: Development Base Package (base board, psu, RS232 and USB cable, user's guide and support software)
DS.TCP/IP-DM642: Ethernet Development Support Package
DK.DM642: Complete standalone DM642 Development Kit including D.Module2.DM642 DS.DM642, DS.TCP/IP, cable, PSU +3,3V, XDS510PP Plus Emulator and Code Composer Studio (is also available with XDS510 USB, XDS510 USB+ or XDS560 USB emulator)
